Does anyone know of a place that will bend a piece of pipe /tubing for the public 1.5 in outside diameter thin wall close to Decatur Tx?

Would think any muffler shop should be able to do it.

Good answer. Almost every muffler shop has a pipe bender so if it's thin wall like exhaust pipe they can probably help you.

Do you need the diameter to be the same in the bends? If so, you need to find someone with a mandrel pipe bender.

Yes it needs to be the same size in the bends thanks for the information

WD Welding in Springtown should be able to do it. 817-879-1111

Ok thanks

Ive heard of packing pipe with sand & bending it without a bender, but 1 1/2 seems kinda big for that

Any good electrical company can bend it for you, they have benders up to at least 4 inches,

Worthtex west of Boyd I think can do that.
(940) 433-3200

mandrel is the only bender that will keep the dia. in the bend.

What material? Depending on your answer, I will probably recommend annealed tubing. That makes it suitable for bending.

It is a tall order to have the ID be the same within the bend. Do you know the bend radius you need? For example, if you are workin with stainless steel, you could buy some sweep ninety or 45 degree bends welded to straight lengths if you absolutely need the ID to be the same.

I suspect this is decorative, or structural and not process related. You may be looking at chrome tubing or something.

i found a place in Decatur that can bend 1.3/4 in and that will work I'm using it for a handle for steps i put on the tongue of my trailer.

I was a little nervous to open this thread

So I was't the only one...

Nope