Posted By: Texjef84
Need a new transducer for my 858C HD DI at the bow. - 05/11/17 10:19 PM
If anyone has a XNT-9-DI-T, which I believe is the transducer I need for my bow unit. Replaced the trolling motor and routed the cable in a way that crimped the transducer cable is all I can figure but the HB is not worth turning on until I replace the transducer. If no one has an extra, used is fine, I'll go buy one Monday.
Posted By: Wayne P.
Re: Need a new transducer for my 858C HD DI at the bow. - 05/11/17 10:55 PM
Use the correct one for the trolling motor---a trolling motor PUCK.
It has extra internal shielding and needs no mount, it comes with stainless steel hose clamps.
Two choices for the PUCK
XTM 9 DI 25 T has the same frequency tuned 2D crystal as the transom version.
XTM 9 WIDE DI 20 T is tuned for 83/200 kHz 2D sonar.
Check your Connected Transducer choices in the Sonar Menu to see if you have the DI 83/200 kHz choice to use the WIDE version.
Posted By: Texjef84
Re: Need a new transducer for my 858C HD DI at the bow. - 05/11/17 11:21 PM
As always Wayne, thank you. I'm hoping to get a couple of Helix units in the near future