Hds 8 gen 2 temp

I haven't had a temp reading for a while. Showed no source. I put a new lss2 box on and had temp. The sonar was hesitating so I did a soft reset. Everything is good now but it shows water temp of 112. Only shows temp on structure scan nothing on regular sonar.
Any suggestions?

Make sure your transducer has temp. function. If so, on HDS unit......

Select Sonar
Select Data Overlay
Select Add Temp.

Thanks

You probably already did this, but make sure that your transducer isn't damaged at all.

The transducer and sensor setting on HDS units are under DATA SOURCES. You'll need to check the boxes on th unit to tell it where to read the source from.

Also, make sure you have the correct TD selected in the intitial setup. Selecting the wrong TD will cause sources not to work right.