I'm sure this has been brought up, but I have been unable to find it on my phone. I am just getting into painting some baits, I was wondering if anyone had any information on where they have gotten or get their stencils? Again, if this is a repeat post I apologize.

I made my own with thin sheet of plastic. You can take a one gallon paint can put a hole in the bottom to put a vacume hose to, then poke holes in the top lid. heat the thin sheet of plastic then put your crankbait underneath it and it sucks the thin plastic up against the crankbait while its still hot. there is some youtube videos on how to make it. Kinda hard to explain on here, but that's how I made mine, hope this helps

I think this guy also sells them preformed and cut.