|
Forums59
Topics1,039,295
Posts13,962,404
Members144,197
| |
Most Online39,925
Dec 30th, 2023
|
|
 Motor won't shut off
#11279158
12/13/15 03:16 PM
|
Joined: Oct 2002
Posts: 6,102
ring fry
OP
TFF Celebrity
|
|
OP
TFF Celebrity
Joined: Oct 2002
Posts: 6,102 |
OK, went out yesterday and fired up the motor, parked at the dock and turned the key off. Motor didn't miss a beat, kept running. Pulled the key out and it continued to run. Only way I could get it to shut down was to pull the safety lanyard on the kill switch. 01 Mercury XR6. Help???????????????
SE Kansas grass grower
2008, 2022 NCAA Men's Basketball Champions
GO JAYHAWKS
|
|
|
Re: Motor won't shut off
[Re: ring fry]
#11279270
12/13/15 04:22 PM
|
Joined: Jan 2009
Posts: 1,650
spankyttx
Extreme Angler
|
|
Extreme Angler
Joined: Jan 2009
Posts: 1,650 |
it's not uncommon for the ignition switch to go bad, seen it happen several times
LI-SI-WI-NWI
|
|
|
Re: Motor won't shut off
[Re: ring fry]
#11279595
12/13/15 07:29 PM
|
Joined: Nov 2006
Posts: 2,850
TLW
Extreme Angler
|
|
Extreme Angler
Joined: Nov 2006
Posts: 2,850 |
agree.. kill switch works so pretty much tells ya its ign. key switch...
|
|
|
Re: Motor won't shut off
[Re: ring fry]
#11281025
12/14/15 01:26 PM
|
Joined: Nov 2014
Posts: 23,429
SteezMacQueen
TFF Guru
|
|
TFF Guru
Joined: Nov 2014
Posts: 23,429 |
Or a bad ground. The key switch basically grounds the magneto, stopping power to the coil.
Eat. Sleep. Fish.
|
|
|
Re: Motor won't shut off
[Re: ring fry]
#11282246
12/14/15 11:21 PM
|
Joined: Nov 2006
Posts: 2,850
TLW
Extreme Angler
|
|
Extreme Angler
Joined: Nov 2006
Posts: 2,850 |
tha blk/yellows (kill circuit) make up before they go to tha key switch.. there is only one blk/yellow and one ground goin' to tha key that will "make" when its turned to tha off position.. (like ya said, same as pushin' tha metal tab against tha spark plug ona 'ole briggs n stratton rottary mower!).. both of these are parallel to tha ground and blk/yellow goin' thru tha "kill (lanyard)" circuit.. thats why it indicates either one of tha wires (blk/yellow or just blk) may be bad between tha joints made in tha harness and key switch or contacts in tha switch itself.. maybe this link will work and you can see it.. i know it says yamaha but its a merc... http://www.emprendedor.us/yamaha-outboard-key-switch-wiring-diagram/2/key-switch-wiring-diagram/
Last edited by TLW; 12/15/15 12:20 AM.
|
|
|
Re: Motor won't shut off
[Re: ring fry]
#11283118
12/15/15 12:16 PM
|
Joined: Oct 2002
Posts: 6,102
ring fry
OP
TFF Celebrity
|
|
OP
TFF Celebrity
Joined: Oct 2002
Posts: 6,102 |
OK thanks. I did make a new face plate for the key switch as the plastic one was cracking. I bet I might have disconnected the ground wire as I was pulling on the switch to get it in the new face plate.
SE Kansas grass grower
2008, 2022 NCAA Men's Basketball Champions
GO JAYHAWKS
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
