Forums59
Topics1,039,267
Posts13,961,847
Members144,197
|
Most Online39,925 Dec 30th, 2023
|
|
Lowrance HDS on Trolling Motor
#12227878
05/03/17 12:47 AM
|
Joined: Sep 2006
Posts: 2,227
TBS
OP
Extreme Angler
|
OP
Extreme Angler
Joined: Sep 2006
Posts: 2,227 |
I have a Lowrance HDS GEN 3 on the trolling motor and at the console. I have a down imaging transducer mounted on the transom. The transducer on the trolling motor has broken off and I want to replace it with a down imaging transducer. How do I do that? Do I use the same model down imaging transducer that is on the transom? Is there an adapter to make it fit on the trolling motor? Help me out TFF. Thanks
Last edited by TBS; 05/03/17 01:34 AM.
"I Ain't Often Right But I've Never Been Wrong"
|
|
Re: Lowrance HDS on Trolling Motor
[Re: TBS]
#12228009
05/03/17 02:13 AM
|
Joined: Jun 2005
Posts: 1,014
jfdawson
Extreme Angler
|
Extreme Angler
Joined: Jun 2005
Posts: 1,014 |
You have a couple to options but since you mentioned "breaking off" the sonar TD, I would recommend the HDI 83/200/455/800 Transducer and then buy the Transducer Shield and Saver bracket to mount it to your TM. You'll also need 2 stainless ring clamps. For the transome, I would get the TOTAL SCAN TD, and take advantage of sidescan. Plus it's 1 transducer that does it all: 2D, Downscan, and sidescan. You could swap the rear HDI to the TM, and add the TotalScan. Then you'd have the what you need. The HDI will give you 2D sonar and Downscan together.
|
|
Re: Lowrance HDS on Trolling Motor
[Re: jfdawson]
#12279788
06/05/17 08:45 PM
|
Joined: Jun 2012
Posts: 973
benp
Pro Angler
|
Pro Angler
Joined: Jun 2012
Posts: 973 |
what do i do with the transducer wire if i use the Transducer Shield and Saver bracket? do i wrap it in the air hose and if i do not fish shallow should i not just use the Lowrance 000-10978-001 HDI Trolling Motor Adapter?
thx!
I only fish on days that end in Y!
|
|
Re: Lowrance HDS on Trolling Motor
[Re: TBS]
#12279896
06/05/17 09:55 PM
|
Joined: May 2009
Posts: 978
MAK747
Pro Angler
|
Pro Angler
Joined: May 2009
Posts: 978 |
What model trolling motor? What model transducer do you currently have on the transom? If it is an HDI, then I would recommend moving it to the trolling motor and then getting an LSS for the transom. You will also need a 2D transducer mounted either to the transom or in the bilge. If you decide to mount it the bilge, make sure the transducer has either no Temp. sensor or a remote one.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|