Can anyone give me any tips on the pumkin brown powder coat. It runs when I cure it in the oven. I've tried lower temp, shorter time, lighter coats on the jig head. I've baked around 10 colors and have had no problems with any other color.
I do not use that color, but I also know some colors seem not need the lead to have been in the fire as long as another one. So ones I know are prone to get too much paint on, I just hold in the fire a little less time and seems to work fine for me. I do not change my heat or time in over ever unless I am using Pearl White which demands a lower temp! I keep my temp between 390 and 400 and have actually put a thermometer in my toaster oven so I would know where it has to be set to reach the themes I want. If I use my large oven then I just use it's settings, but the small ovens are usually not accurate on temps. So I also know if I take a load out and put a new load in it's cooled and will take almost 2 minutes to reach temp so I cure for 17 minutes as I need 15 minutes with the lead at themes as that is what that means, the lead need to be at that temp to cure right.
So for that color I would just find how long I need leave it in the fire/heat to determine the right amount of paint so it downs drip! Way back when I started I seemed to always have trouble with Black dripping so finally I just adjusted the length of time in the fire and a 2 count. I count not by real seconds, but more just my cadence.