Some Power Pole Bling

Very nice! Do you have those in red? I have two red signatures.

serious pimpin'

I use a brighter led then the deck & will have to see if I have some. I do have the deck lights in red just not as bright.

Oh snap

how did you run the wires, I have been wanting to do this on my duals, but red.

Nice

Very nice set up. What does it set you back?

So is this Fred's boat?

That is Boom Boom boat. It turned out great but picture didnt.

We ran the wires through the same loom as the hydro lines.

About $30 per pole.



Here is a blue but dont have a picture of the red yet.

kool.

Nice

Ballin!!

Ok so do you sale these yet? I want some red ones.

Do you have in black lights or even a purple light. I have black lights already mount to rubrail and want to match them. Although I do have a red signature pole.....hmm

My question is if you mounted a white light on them, would this count for your navigational light? They would be brighter no doubt.

ATM--- If its not coast guard approved then you can get a ticket for it. More light never hurts but keep you regulation light in and turned on also... Just my advise after checking on this a while back. Wardens are looking for reasons to write a ticket.

Depends on the game warden & coast guard. I have go the ok on the red & green in the front but havent done anything on the rear. Mike at Bluewater LED offers a white kit of four lights on the power pole.

I dont have any purple at this time but will be adding some.

How difficult are they to install?

nice

how's the new four stroke engine?

Zach Caudle just have to run the wires to your power source. The lights are held on with a heavy duty 3M tape.

reggier- I wish this was my boat but the owner says in runs sweet.

When you get some red ones in Id love to have a set. Do you run them on a switch or just to the nav lights or courtesy lights?

I would run them on a seperate switch just to be safe. You can put it on one of your extra switches or I can get you a lighted red rocker switch.

I have noticed some people have their front running lights put into the rub rail. How is this done? Replace the whole rub rail? Or insets?

The ones that I have seen, they cut out the middle section on the rub rail.

i would win a tournament first;)