Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
szunnyadtmacska, Ring The Bell, Krumfishing, Fishing is the best, rnger518
104794 Registered Users
Top Posters
TexDawg 84879
hopalong 77242
Pilothawk 74616
JDavis7873® 67382
John175 ® 63096
FattyMcButterpants 60665
Derek 🐝 57554
Tritonman 57447
SkeeterRonnie 52884
LoneStarSon® 52769
facebook
Forum Stats
104794 Members
60 Forums
791061 Topics
10000060 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#3911970 - 09/09/09 11:03 AM External Transducer on a Minn Kota Power Drive V2
M&M13 Offline
Pro Angler

Registered: 05/15/08
Posts: 696
Loc: Frisco
Does anyone know how to go about mounting an external transducer on a Minn Kota Power Drive V2? it just doesn't look like it can happen with the way the shaft is.
_________________________

Top
#3917938 - 09/10/09 04:58 PM Re: External Transducer on a Minn Kota Power Drive V2 [Re: M&M13]
M&M13 Offline
Pro Angler

Registered: 05/15/08
Posts: 696
Loc: Frisco
TTT
_________________________

Top
#3920653 - 09/11/09 11:59 AM Re: External Transducer on a Minn Kota Power Drive V2 [Re: M&M13]
M&M13 Offline
Pro Angler

Registered: 05/15/08
Posts: 696
Loc: Frisco
How bout a bump!!
_________________________

Top
#3930915 - 09/14/09 08:02 AM Re: External Transducer on a Minn Kota Power Drive V2 [Re: M&M13]
M&M13 Offline
Pro Angler

Registered: 05/15/08
Posts: 696
Loc: Frisco
TTT
_________________________

Top
#3932750 - 09/14/09 03:23 PM Re: External Transducer on a Minn Kota Power Drive V2 [Re: M&M13]
Txdeuce Offline
Pro Angler

Registered: 08/25/07
Posts: 856
Loc: Boerne, Texas
Good question. The Power Drive V2 has the coiled cables, right?

Top
#3933128 - 09/14/09 04:47 PM Re: External Transducer on a Minn Kota Power Drive V2 [Re: Txdeuce]
M&M13 Offline
Pro Angler

Registered: 05/15/08
Posts: 696
Loc: Frisco
Right and the shaft slids.

_________________________

Top
#3938721 - 09/15/09 10:08 PM Re: External Transducer on a Minn Kota Power Drive V2 [Re: M&M13]
Wade Offline
Outdoorsman

Registered: 09/06/05
Posts: 135
Loc: Euless, TX
I have a Power drive trolling motor, and the manual states to drill a hole in the rib on the top side of the head, and then run the cable up thru the handle and then thru the coil cable. the illustration shows the cable attached near the top of the unit.and no attachment on the shaft so that it can slide up and down.

hope this helps.

w

Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide