will a motor guide trolling motor prop fit a minn kota trolling motor?

If not, will the pin for the motor guide prop fit the prop for the minn kota?

In a bit of a bind for fishing tomorrow, need quick help! Anyone know any remedies for fitting?

ac

Find an Academy that's still open.

I've cut out a piece from a five gallon bucket handle to make due when I was on the water stuck before in a tournament. Not sure about the sizing differences between the Minn and the Motorguide though.

Sounds like you need a pin, not too sure about the prop compatibillity. I used a drill bit of the same diameter of the hole once when mine broke. Just find the right size measure the lenght you need, put it in a vise, and take a hammer and break the rest off. Itll get you out and back if thats what you need!

Where are you located? I have an extra pin for a minnkota.

located in rockwall, you fishing the catch'm and cull'm tomorrow skeeterhawk?

Use a nail, find the right diam, then cut to length.

a coat hanger has gotten us by for a couple of days.

Hey I'm very sorry I didn't get back to you.You should have called me.Myphone number is in my sig.

Yes I fished yesterday.Couldn't get a fish long enough to weigh.Had one that was a 1/16th of an inch too short.

Didn't make the weigh-in trying to get my partner to catch at least one fish.He hooked one on a spinnerbait that was about 6 inches long and it got off right at the boat.DOH

Did you find you a pin?

you need me to show you some places to fish, SH???

What was that SkeeterRonnie?

I can't hear you.

I cut an impromptu pin from one of those stringers with the metal clips on them a couple months ago and it is still holding up well.

sure, I keep catching either the babies from your monsters or the little sister...LOL..

If you want just the pin, go to Bass Pro Parts/service department. Academy only had the $8 package that came with pin, nut, and a washer I think. Got 3 pins for less than $5 at BP.

+1