Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Jbrown18, Travisly4, Russline, Rev.,Dr.Thaddious, Robere
107989 Registered Users
Top Posters
TexDawg 88591
hopalong 78895
Pilothawk 76386
John175® 67548
JDavis7873® 67390
FattyMcButterpants 60868
Derek 🐝 60239
Tritonman 57988
LoneStarSon® 54394
SkeeterRonnie 53365
facebook
Forum Stats
107989 Members
60 Forums
860839 Topics
12269520 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#12756789 - 05/15/18 05:48 PM H.b, install
Lazy Ike Offline
Angler

Registered: 03/09/16
Posts: 333
Loc: garland
thought I would ask you experienced guys how too feed my gps cable & transducer cable thru opening in splah well where all wires, cables etc. go thru to console for motor, thanks for tips.Hope to get my 1198c going.

Top
#12756896 - 05/15/18 07:14 PM Re: H.b, install [Re: Lazy Ike]
sprigsss Online   content
Pro Angler

Registered: 02/11/11
Posts: 532
Loc: Snyder, TX
Disconnect 1 known cable, tie string to it and pull to rear.

I normally make a loop with cable and use electrical tape to tape plug to wire so it doesn’t get hung up as bad.

I like the tarred trot line string because it doesn’t fray, but any similar sized string should work.

I’d pull a few lines through for next time and in case you break a line.

Then next time you pull a cable, pull another length of line with it so it’s already there.

Top
#12757123 - 05/15/18 09:19 PM Re: H.b, install [Re: Lazy Ike]
Bobby Milam Online   content
TFF Team Angler

Registered: 07/13/14
Posts: 3361
Loc: Arlington
I just use a fisher tape and feed it thru from the transom end with a string attached. I too tie a couple of extras on to leave in place. Then pull the new wire thru from the console side. Just be patient and work it thru slow so you dont damage or knock loose anything else.

Top



© 1998-2018 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide