Forums59
Topics1,039,271
Posts13,961,935
Members144,197
|
Most Online39,925 Dec 30th, 2023
|
|
What are the holes on the backside of this carburetor for?
#12700229
04/02/18 11:22 PM
|
Joined: Dec 2012
Posts: 726
BrazosRiverTom
OP
Pro Angler
|
OP
Pro Angler
Joined: Dec 2012
Posts: 726 |
What are the top oblong hole and the tall long hole/indenture used for? Please ignore the round black dot, I did that with a marks a lot, was thinking about drilling hole there but changed my mind. Reason I ask is I was thinking about filling it in with JB Weld as that top oblong hole sticks out above the intake manifold just a little enough so I can slip a paper clip in it. It is only covered by the gasket not metal/gasket/metal when bolted on. I would leave the intake side alone and it would still be open to both carb barrels. Any help appreciated.
Last edited by BrazosRiverTom; 04/02/18 11:22 PM. Reason: Spelling correction
|
|
Re: What are the holes on the backside of this carburetor for?
[Re: BrazosRiverTom]
#12700266
04/02/18 11:57 PM
|
Joined: Dec 2013
Posts: 459
PlanoPaul
Angler
|
Angler
Joined: Dec 2013
Posts: 459 |
Looks like you got you an early to mid 80s Johnyrude there. Gotta believe that void in the center is just part of the mold and serves no purpose, the oblong hole on top is probably a vent. I think id take it easy with the JB...
|
|
Re: What are the holes on the backside of this carburetor for?
[Re: BrazosRiverTom]
#12700281
04/03/18 12:09 AM
|
Joined: Dec 2012
Posts: 726
BrazosRiverTom
OP
Pro Angler
|
OP
Pro Angler
Joined: Dec 2012
Posts: 726 |
Thanks was thinking the lower was just for mold too. Now the upper has no hole inside the hole, it is just an indenture, that is suppose to match up with the intake and probably vent gases? If I seal it up the intake hole and indenture to both barrels would still be open. Your right 1981 Evinrude 115hp carbs trying to mount on a 1978 Johnson 115 powerhead and run fuel primer lines to the bypass covers.
|
|
Re: What are the holes on the backside of this carburetor for?
[Re: BrazosRiverTom]
#12700985
04/03/18 02:43 PM
|
Joined: Dec 2013
Posts: 459
PlanoPaul
Angler
|
Angler
Joined: Dec 2013
Posts: 459 |
If it doesnt lead anywhere, then id say that is just part of the mold also. Dont believe id worry about modifying anything, hopefully Im understanding this correctly.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|