Main Menu
Newest Members
tsasunkawitka, OldTriton, shooter60, Chrishow09, Larry Milford
108886 Registered Users
Top Posters
TexDawg 89609
hopalong 78895
Pilothawk 76944
John175® 68883
JDavis7873® 67392
Derek 🐝 61282
FattyMcButterpants 60904
Tritonman 58263
LoneStarSon® 54732
SkeeterRonnie 53599
Forum Stats
108886 Members
60 Forums
782918 Topics
10102700 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#12678306 - 03/18/18 03:55 PM Ultrex question
Doing it for the fans since 71 Offline
Pro Angler

Registered: 08/22/12
Posts: 522
used mine yesterday for the 1st time. When I let off the gas it would continue to run. Then I would tap the gas and it would stop. Is this normal? I am hoping it's just me and I need to hit some button or something. Any advice?

#12678314 - 03/18/18 04:02 PM Re: Ultrex question [Re: Doing it for the fans since 71]
361V Offline
TFF Celebrity

Registered: 11/21/08
Posts: 5133
Loc: somervell county
Sounds like a bad/sticky power switch.

#12678325 - 03/18/18 04:18 PM Re: Ultrex question [Re: 361V]
Mike Keenan Online   content
TFF Guru

Registered: 10/31/04
Posts: 10960
Loc: San Diego, Ca/ Sanger, Tx
Only issue I’ve had with mine, the coiled wire came apart from both ends. I had to disassemble the plugs to get everything back together like it should be. That was a pain in the butt.
R.I.P. Mike "pappy" "broken rod" Green born 07-16-62 on to better fishing 06-10-08.

#12678331 - 03/18/18 04:21 PM Re: Ultrex question [Re: Doing it for the fans since 71]
Stompy Online   content
Extreme Angler

Registered: 03/22/10
Posts: 1100
Loc: Breckenridge Tx
I'll post this again for others to see.

The momentary switch that is staying on problem is easily fixed, the switch needs to be adjusted. There is a reed switch (magnetic switch) under foot button. Pop off the foot button carefully by depressing tab underneath momentary button. Once the button is off you will see the reed switch (small round thing) you adjust by pushing it down or up. You will need to push it down just a tiny bit so reed switch doesn't make as much contact when not depressed so it will turn off. I use a flat blade screwdriver. Only move a tiny bit. Little goes a long way. After adjustment pop momentary button back on and try it. You may have to adjust a couple times to get it right. But simple to do. 
Cabin Rentals on the ranch for Hubbard Creek Lake

#12678438 - 03/18/18 06:00 PM Re: Ultrex question [Re: Doing it for the fans since 71]
SteezMacQueen Online   sleepy
TFF Celebrity

Registered: 11/02/14
Posts: 6051
Loc: Red Oak, Galveston, and Pagosa...
I didn't know what was going on with mine today. I was stuck in circles.....kinda suck when bed fishing. Haha. I broke one of the steering cables. Looks like an easy enough fix. $44 shipped. I figured it was my fault. Not even gonna bother with a warranty. It'd cost more in gas and down time to take it in.

Cool thing, even with broken cables, I continued to fish with the remote. Try that with any other TM.
Eat. Sleep. Fish.

#12693235 - 03/28/18 01:05 PM Re: Ultrex question [Re: Doing it for the fans since 71]
SwampDonkey Offline

Registered: 06/12/09
Posts: 114
Loc: Texas
I’ve replaced the cables. It’s gonna be fun lol
If it's wet I'll Fish it.


© 1998-2018 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide