Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
ladyangler125, AHS Basser, MoJoMorris, suhil has, Jr baiter
106516 Registered Users
Top Posters
TexDawg 87125
hopalong 78812
Pilothawk 75784
JDavis7873® 67386
John175 ® 65888
FattyMcButterpants 60793
Derek 🐝 59024
Tritonman 57763
LoneStarSon® 53818
SkeeterRonnie 53123
facebook
Forum Stats
106516 Members
61 Forums
863940 Topics
12277635 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#12450615 - 10/02/17 06:26 PM Yamaha Outboard Operating Range
Bob Landry Offline
Extreme Angler

Registered: 08/10/11
Posts: 2679
Loc: Austin, Tx
I found out while wrestling with props and looking for a SS one, that in 2014 Yamaha increased the operating range off the 115 300RPM, to 5300-6300.
Yamaha has performance bulletins on their site with results of their motors with specific boats so you can see how they should be propped. The one for my boat and motor was done with the older motors with the lower operating range and with a prop that is no longer available. Lot's of head scratching trying to figure out why they propped my motor the way they did and trying to get the numbers to make sense when applying them to my boat and the newer 115 Yammie.
Just wondering if they increased to operating ranges across the board or just on a few select motors.
_________________________
2015 Seaark 1872 MV CC Etec-90
Two Helix 12 CHIRP SI's, , MinnKota Riptide ST80/i-pilot Link, Bob's Hydraulic
2018 Robalo R180 CC, Yamaha 115

Bitter Gun Owner
Bitter Clinger
Armed Infidel

Top
#12457140 - 10/07/17 07:56 PM Re: Yamaha Outboard Operating Range [Re: Bob Landry]
Gamblinman Online   content
TFF Team Angler

Registered: 11/26/02
Posts: 3047
Loc: Yantis, TX
Refer to the operators manual, or, the info sticker on the motor itself. You should prop your boat to reach at or near it's maximum operating RPM's when normally loaded at WOT.
_________________________
Texas Crappie Posse

Top
#12457681 - 10/08/17 08:06 AM Re: Yamaha Outboard Operating Range [Re: Bob Landry]
Muzzlebrake Offline
Extreme Angler

Registered: 12/26/14
Posts: 1627
Loc: Euless
Slightly under propped is better than over propped. As for the rev limiter, it's your hand on the throttle control and trim switch. Over propping and lugging the motor ain't good for them, especially on hole shots.
_________________________
From Genesis: "And God promised men that good and obedient wives would be found in all corners of the earth."

Then He made the earth round...and He laughed and laughed and laughed!


Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide