Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
ukagoh, george78223, BigWormWorker(SirKels), carlos flournoy, Natemanz
105433 Registered Users
Top Posters
TexDawg 85609
hopalong 78097
Pilothawk 74933
JDavis7873® 67382
John175 ® 64312
FattyMcButterpants 60667
Derek 🐝 58029
Tritonman 57517
LoneStarSon® 53053
SkeeterRonnie 52940
facebook
Forum Stats
105433 Members
60 Forums
848231 Topics
12089848 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#12301492 - 06/19/17 04:19 PM X21 with 200 Xri Mercury jack plate height????
fish-n-elmo Offline
Outdoorsman

Registered: 06/02/07
Posts: 207
Loc: Weatherford
I have a 2000 Xpress X21 with a 200 Xri Merury on it . Currently my prop shaft is 6" below pad. From what I have read 3.5" below is where to start for setting up for best performance. I currently have 25 p Temptest plus 3 blade on it and also have a Trophy plus four blade 24 pitch. So I need to raise it...any other advice? Thanks!


Edited by fish-n-elmo (06/19/17 04:23 PM)

Top
#12301556 - 06/19/17 04:52 PM Re: X21 with 200 Xri Mercury jack plate height???? [Re: fish-n-elmo]
Pat Goff Online   content
TFF Celebrity

Registered: 01/29/05
Posts: 5154
Loc: Marble Falls/Seadrift
Internet knowledge is suspect.
Your iron hull can't run as high as a comparable fiberglass, so that's wrong information there.

There is ONLY ONE way to set up your rig, go run it with a regular fishing load, bring the plate up 1/4" at a time until you lose speed, lift or water pressure, then back a click and THEN you'll know where YOUR setup really is.
_________________________
Pat Goff
Marble Falls/Seadrift TX



Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide