Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
kbarnes027, Fxrspud 12, Bryce Everest, gclarkla, ToasterWEyes
106343 Registered Users
Top Posters
TexDawg 86893
hopalong 78788
Pilothawk 75537
JDavis7873® 67385
John175 ® 65709
FattyMcButterpants 60793
Derek 🐝 58852
Tritonman 57701
LoneStarSon® 53688
SkeeterRonnie 53096
facebook
Forum Stats
106343 Members
61 Forums
861696 Topics
12247663 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#12259496 - 05/23/17 04:16 PM Inside Transom Silicone Question
BrazosRiverTom Offline
Pro Angler

Registered: 12/15/12
Posts: 545
Loc: Mineral Wells, TX
I recently had my gas tank out of my 1978 Ranger Bass boat doing repairs. I noticed that the silicone around two of the large washers (that go to the motor mount bolts) was peeling away so I pulled the rest of it off, intending to go around the washers and put new stuff on. Well I forgot and I reinstalled the gas tank. My question is since it is on the inside and it is not likely water will get that high without sinking first. Do I need to go back in and put new silicone around the washers or just not worry about it? Appreciate any advice.


Edited by BrazosRiverTom (05/23/17 04:17 PM)

Top
#12260301 - 05/24/17 07:40 AM Re: Inside Transom Silicone Question [Re: BrazosRiverTom]
steve@hydrodynamics Offline
TFF Celebrity

Registered: 08/25/06
Posts: 6777
Loc: Quitman,Tx
as long as their is good silicone on the outside and its not leaking, you should be okay.

i use 3m 4200 when i install a jack plate.
_________________________
www.hydrodynamics-usa.com
903-763-5225





Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide