Forums59
Topics1,039,169
Posts13,960,301
Members144,192
|
Most Online39,925 Dec 30th, 2023
|
|
Lowrance hook 9
#11965673
12/04/16 07:31 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
I am getting ready to install the above on my 17 foot deep v alum and any helpful do's an d don't will be appreciated. The transducer will be mounted on left side of transom, the unit will replace my eagle 640 c. Unit will be on the bow platform . Figure I will be able to read unit from console. If not will reinstall on the console. Promised myself I would not install until I have read and understand the manual. Any advice will be appreciated.
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#11965794
12/04/16 08:52 PM
|
Joined: Nov 2015
Posts: 95
wallyandre
Outdoorsman
|
Outdoorsman
Joined: Nov 2015
Posts: 95 |
|
|
Re: Lowrance hook 9
[Re: ebl]
#11973707
12/08/16 08:42 PM
|
Joined: Oct 2016
Posts: 536
Bulletman99
Pro Angler
|
Pro Angler
Joined: Oct 2016
Posts: 536 |
Make sure you install it with plenty of room in the back to install/remove cables. They can be a pain!!!!!
Bullet 20XD Merc 250 ProXS
|
|
Re: Lowrance hook 9
[Re: ebl]
#11974321
12/09/16 02:42 AM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
Bulletman... Larned that the hard way when I intalled the 640 c
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#11974686
12/09/16 01:34 PM
|
Joined: May 2011
Posts: 563
Jones Trolling Motor
Pro Angler
|
Pro Angler
Joined: May 2011
Posts: 563 |
a 17', installed on the bow and the transducer on the transom -- Install the transducer first and run the cable. This may dictate the location of the fishfinder. I don't remember how much cable is on the transducer.
|
|
Re: Lowrance hook 9
[Re: ebl]
#11974846
12/09/16 02:58 PM
|
Joined: Aug 2011
Posts: 2,957
Bob Landry
Extreme Angler
|
Extreme Angler
Joined: Aug 2011
Posts: 2,957 |
I bet Lowrance can tell you how long the cable is.
2015 Seaark 1872 MV CC Etec-90 Two Helix 12 CHIRP SI's, , MinnKota Riptide ST80/i-pilot Link, Bob's Hydraulic 2020 Robalo R200 CC, Yamaha 150
Bitter Gun Owner Bitter Clinger Armed Infidel
|
|
Re: Lowrance hook 9
[Re: ebl]
#11974980
12/09/16 03:49 PM
|
Joined: Nov 2015
Posts: 95
wallyandre
Outdoorsman
|
Outdoorsman
Joined: Nov 2015
Posts: 95 |
Transducer cable length is 20ft and you can get a 12ft extension cable part#: 000-0099-93
|
|
Re: Lowrance hook 9
[Re: ebl]
#11976889
12/10/16 08:42 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
The cable that camew with nit is long enough so should,t need extension
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#11976892
12/10/16 08:43 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
The cable that camew with nit is long enough so should,t need extension
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#11998422
12/22/16 04:54 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
cABLE INSTALLED AND WITH ROOM TO,SPARE
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#12014192
01/01/17 05:13 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
In boat and on water and WOW ! what a picure,didn't know how well it performed.
eddie b lane
|
|
Re: Lowrance hook 9
[Re: ebl]
#12026004
01/07/17 03:56 PM
|
Joined: Nov 2014
Posts: 164
ebl
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Nov 2014
Posts: 164 |
After installing and learning the following is happeningafter installing power and trnsducer lines in the same location of the replaced eagle 40c i get a snowy screen at 2800 rpm. visited with tech support(lowranc with this suggestion. go ith a 12ga power instead of 16 and sheild transducer cable in aaromed metal conduit. Any thousght sugestion will be appreciated
eddie b lane
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|