Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Storyteller, Thomas Huffman, Sciaenops, MarkMaker, StevenChase
104770 Registered Users
Top Posters
TexDawg 84835
hopalong 77195
Pilothawk 74573
JDavis7873® 67382
John175 ® 63057
FattyMcButterpants 60663
Derek 🐝 57528
Tritonman 57443
SkeeterRonnie 52878
LoneStarSon® 52763
facebook
Forum Stats
104770 Members
60 Forums
790693 Topics
9995464 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11926044 - 11/09/16 03:39 PM Mounting Total Scan Transducer
randywillfish Offline
Outdoorsman

Registered: 04/02/10
Posts: 234
Loc: JACKSONVILLE, TEXAS
I have a 2009 Skeeter Z-190 with 150 Yamaha and factory jack plate.
I am looking at getting a Lowrance Elite 7 Ti in a few months.
I fish a small lake with LOTS of stumps and lay downs(Naconiche).
What can I do, or where do I mount the transducer where I won't have to worry about dragging it off on a log?

Or am I better off sticking with a lake with no cover?

Need y'alls advice....


Edited by randywillfish (11/09/16 03:43 PM)

Top
#11926147 - 11/09/16 04:30 PM Re: Mounting Total Scan Transducer [Re: randywillfish]
Jones Trolling Motor Offline
Angler

Registered: 05/01/11
Posts: 460
Loc: NE Texas/SW Arkansas
Since total scan will not ready while on plane, mount it on the actual transom, as close to the center as possible where it won't pick up motor noise or e hit by the outboard when trimmed down. Make sure it has a clear view to both sides and the Skeeter's sponson's are not in the way. If you think about it, when you hit a stump, very rarely does it go right down the center. The "vee" moves it away from the center line of the boat.
_________________________

www.jonestrollingmotor.com
texarkana, Ark/Tx

Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide