|
Forums59
Topics1,039,143
Posts13,959,892
Members144,192
| |
Most Online39,925
Dec 30th, 2023
|
|
 ranger 520VX gas gauges.
#11864531
10/04/16 08:36 PM
|
Joined: Feb 2005
Posts: 2,111
z NICK
OP
Extreme Angler
|
|
OP
Extreme Angler
Joined: Feb 2005
Posts: 2,111 |
I have a 2004 Ranger 520VX with touch pad and regular gas gauge. Both gas gauges are stuck on full no matter which tank i choose on touch pad.
I am decent at working on things. Is this possible I can fix myself? I don't think it would be the sender unit if both arent reading right?
Any help would be appreciated.
 Whether you think you can, or you think you can't... Your right--- Henry Ford
|
|
|
Re: ranger 520VX gas gauges.
[Re: z NICK]
#11865061
10/05/16 01:52 AM
|
Joined: Jan 2010
Posts: 246
79Ranger168V
Outdoorsman
|
|
Outdoorsman
Joined: Jan 2010
Posts: 246 |
I just fixed mine on my 521vx. First remove the seats. To do that you remove the center fusion on the two seat backs and there are two screws behind each one. Then slide the seat forward slightly and lifting up and out of the way. You will now see the fuel tanks and the sending unit on each one. Take one wire off of the sender and touch it to the other with the power on and touchpad on each side when you touch them. If the gauge does not move when the wires are touched then the gauge is bad. If it does move the your sending units are bad. Both of my sending units were bad, and I replaced them with mueller units that were a direct fit and about $30 each.
2003 Ranger 521VX 35th Anniversary 250 Yamaha
1979 Ranger 168V 140 Evinrude - Papa Smurf
|
|
|
Re: ranger 520VX gas gauges.
[Re: 79Ranger168V]
#11874966
10/11/16 02:02 PM
|
Joined: Feb 2005
Posts: 2,111
z NICK
OP
Extreme Angler
|
|
OP
Extreme Angler
Joined: Feb 2005
Posts: 2,111 |
I just fixed mine on my 521vx. First remove the seats. To do that you remove the center fusion on the two seat backs and there are two screws behind each one. Then slide the seat forward slightly and lifting up and out of the way. You will now see the fuel tanks and the sending unit on each one. Take one wire off of the sender and touch it to the other with the power on and touchpad on each side when you touch them. If the gauge does not move when the wires are touched then the gauge is bad. If it does move the your sending units are bad. Both of my sending units were bad, and I replaced them with mueller units that were a direct fit and about $30 each. thank you sir, do you remember the model # or which Mueller sending units you installed?
Whether you think you can, or you think you can't... Your right--- Henry Ford
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
