Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Mason777, RealCamSmith, Ol' Swamp Badd, Redneckcrappiedude, Djbfishing
103981 Registered Users
Top Posters
TexDawg 84216
hopalong 75951
Pilothawk 74193
JDavis7873® 67380
John175 ® 62192
FattyMcButterpants 60645
Tritonman 57318
Derek 57168
SkeeterRonnie 52704
LoneStarSon® 52586
facebook
Forum Stats
103981 Members
61 Forums
783052 Topics
9901262 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11855987 - 09/29/16 01:46 PM Fish and ski motor set up
tincan86 Offline
Extreme Angler

Registered: 02/17/09
Posts: 1239
Loc: Kyle Tx
I know the ideal measurement for a bass boat is 3.5 is it the same for a fish and ski? I got a new motor last week and need to set it up. I took it out last night and with the new power I chime-walk a lot, currently it is bolted through the second from the top hole on the motor and sitting around 5 inches below pad. I didn't realize when I hung the new motor. I am planning on moving it to the bottom hole to raise it up
_________________________
Hope for the best,but prepare for the worst

Top
#11857174 - 09/30/16 10:08 AM Re: Fish and ski motor set up [Re: tincan86]
Pat Goff Online   content
TFF Celebrity

Registered: 01/29/05
Posts: 5053
Loc: Marble Falls/Seadrift
3.5 is typical for a motor hung on a jack plate. No plate? Has to be lower.

Porpoising is due to prop losing its bite at the current trim angle and speed, which can be caused by motor being too high. But your question is too vague without knowing details.
What boat,motor,prop?
What is your WFO rpms and speed?
The better the info the better the answer.
_________________________
Pat Goff
Marble Falls/Seadrift TX

Top
#11861590 - 10/03/16 08:05 AM Re: Fish and ski motor set up [Re: tincan86]
steve@hydrodynamics Online   content
TFF Celebrity

Registered: 08/25/06
Posts: 6666
Loc: Quitman,Tx
a chine walking fish n ski?

post some details of what you have. like pat said.

i'm intrigued
_________________________
www.hydrodynamics-usa.com
903-763-5225





Top
#11863596 - 10/04/16 07:29 AM Re: Fish and ski motor set up [Re: tincan86]
tincan86 Offline
Extreme Angler

Registered: 02/17/09
Posts: 1239
Loc: Kyle Tx
1991 ranger 397VS with a 2006 200hp E-TEC. I haven't looked at what prop is on it currently, I received 4 props when I got the motor


Edited by tincan86 (10/04/16 08:05 AM)
_________________________
Hope for the best,but prepare for the worst

Top
#11864761 - 10/04/16 05:46 PM Re: Fish and ski motor set up [Re: tincan86]
Pat Goff Online   content
TFF Celebrity

Registered: 01/29/05
Posts: 5053
Loc: Marble Falls/Seadrift
Free props are like free dogs....suspect.
_________________________
Pat Goff
Marble Falls/Seadrift TX

Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide