Forums59
Topics1,037,810
Posts13,934,908
Members144,150
|
Most Online39,925 Dec 30th, 2023
|
|
Fishing Reeds
#11750306
07/30/16 09:28 PM
|
Joined: Jan 2015
Posts: 56
vicstric
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Jan 2015
Posts: 56 |
Hi all! I live close to EM and Lake Worth. I read lot about fishing the reeds. Can anyone give some tips on effectively fishing reeds? Any time I have tried it, it becomes a lesson in frustration.
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750341
07/30/16 09:59 PM
|
Joined: Jul 2016
Posts: 29
HuknBull67
Outdoorsman
|
Outdoorsman
Joined: Jul 2016
Posts: 29 |
Reeds are a flippers paradise. I look for irregularities in the reed line, such as indentations or pockets and points along the line. I like a 1/2 to 3/4 ( based on how dense the reeds are growing together)Hack Attack round head in Green Pumpkin, Black-n-Blue or Chameleon. I tip with various trailers like PACA Chunks and Rage Craws. I try and give each flip at least a 10 to 20 seconds ( based on reed depth and density) after I pitch it to give the fish a chance to locate it and then I barely move it a time or two, then I swim it out a foot or two let it hit bottom one last time before I bring it back in. I have been amazed at how far a fish will follow a bait before it takes it or not. I also keep what I call a "long Jig" like a Mag 2 or Ol'Monster rigged on a 1/2 ounce Florida weight to give them a different look if the jigs are slow. If I may ask, what specifically was frustrating you when you were fishing?
Peace and Bent Rods
HuknBull67
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750390
07/30/16 10:45 PM
|
Joined: Jan 2008
Posts: 19,772
Donald Harper
TFF Guru
|
TFF Guru
Joined: Jan 2008
Posts: 19,772 |
Three rigs: - Hank Parker Classic spinner bait; fished parallel with the reeds, just as close as you can run it. Keep it in sight as you retrieve it. - T-Rig Lizard in Watermelon/red - 1/32 small split Bullet Pinch weight at the nose of a Fluke in Watermelon/tail dipped Chart. Falls in a dying bait fish circle which is hard to beat.
Pitch both the T-Rig and Fluke in ever nook you can find and looking for those features as mentioned above really pays off.
Each person you work with holds some promise to your future success. Websiite Sponsors: www.eletewater.com - Staying Hydrated www.lakeoviachic.com - Booking Mexico Trips 20 Hot Spot Mapping - GPS Contour Chips - Custom Spinner Baits - Jigs -Spooks Pure Extracts - Minnow-Night Crawler-Crayfish-Craylic
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750403
07/30/16 10:59 PM
|
Joined: Sep 2010
Posts: 2,580
GROD
Extreme Angler
|
Extreme Angler
Joined: Sep 2010
Posts: 2,580 |
With so many reeds on EM mid lake/north how does one depict productive reeds vs. nonproductive? Would think some would naturally be better do to close proximity to deeper water or creek channel swing... But really don't know a lot about fishing reeds... So many good docks out there, I never really do much else.
Last edited by GROD; 07/30/16 11:00 PM.
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750580
07/31/16 12:54 AM
|
Joined: Jan 2008
Posts: 19,772
Donald Harper
TFF Guru
|
TFF Guru
Joined: Jan 2008
Posts: 19,772 |
You can't just say that spot looks good. You have to fish them all over time to know the best spots on any lake. I begin the search with a spinner bait until I catch one then I will pick that section of reeds appart with the lizard and fluke.
Another bait that works great around reeds is a senko with small Chart. blade tail spinner fished weightless.
Each person you work with holds some promise to your future success. Websiite Sponsors: www.eletewater.com - Staying Hydrated www.lakeoviachic.com - Booking Mexico Trips 20 Hot Spot Mapping - GPS Contour Chips - Custom Spinner Baits - Jigs -Spooks Pure Extracts - Minnow-Night Crawler-Crayfish-Craylic
|
|
Re: Fishing Reeds
[Re: HuknBull67]
#11750617
07/31/16 01:14 AM
|
Joined: Jan 2015
Posts: 56
vicstric
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Jan 2015
Posts: 56 |
HuknBull, I am trying to pitch a worm in with a 3/8 - 1/2 oz bullet weight pegged. trying to pitch back into the edge a foot or two but seems like anything the worm touches on the way in gets stuck. I am good at pitching and flipping shallow bushes and wood but reeds give me fits.
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750753
07/31/16 02:17 AM
|
Joined: Mar 2003
Posts: 13,570
SteveHummert
pawpaw
|
pawpaw
Joined: Mar 2003
Posts: 13,570 |
Use a 3/4 or 1 oz weight, I'll make a big difference
Also, depending on the thickness of th reds, use a straight tail worm or a creature bait such as a beaver or craw so that it doesn'tgrab on to the reeds as badly
|
|
Re: Fishing Reeds
[Re: vicstric]
#11750763
07/31/16 02:25 AM
|
Joined: Jul 2016
Posts: 29
HuknBull67
Outdoorsman
|
Outdoorsman
Joined: Jul 2016
Posts: 29 |
Sounds like they are pretty thick in their growth pattern and they can be tricky on soft plastics that are "grabby" in nature. I would try and stick with a jig or use something that is not so "grabby" like a Sweet Beaver or Biffle Bug. I myself have trouble pitching with worms if the reed growth is super dense, even with an ounce or so for weight. I know this might sound a bit weird, but I have caught fish deep in the reeds by going "up and in" instead of right through the face of the reeds. I mean literally pitching the worm higher in the air over the reeds and let the weight pull it down into the water instead of trying to "pitch forward" through the reed line where they can play havoc on longer baits. Hope this helps.
Peace and Bent Rods
HuknBull67
|
|
Re: Fishing Reeds
[Re: vicstric]
#11751470
07/31/16 05:13 PM
|
Joined: Mar 2010
Posts: 2,884
DKennimer
Extreme Angler
|
Extreme Angler
Joined: Mar 2010
Posts: 2,884 |
Appendages can really hinder your fishing in reeds. Try a little Yum dinger. Motor oil/chart tail. The old creme worms work good too, they are harder and don't stick to reeds/willow branches/roots as bad.
|
|
Re: Fishing Reeds
[Re: vicstric]
#11751499
07/31/16 05:39 PM
|
Joined: Jul 2013
Posts: 6,681
Brent S
TFF Celebrity
|
TFF Celebrity
Joined: Jul 2013
Posts: 6,681 |
I hate Fishing reeds. Would rather fish grass any day over them. More than likely because I am probably not Fishing them right. If the reeds are sparse then I don't mind though.
|
|
Re: Fishing Reeds
[Re: DKennimer]
#11751501
07/31/16 05:40 PM
|
Joined: Jan 2015
Posts: 56
vicstric
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Jan 2015
Posts: 56 |
Thanks all for the tips. I will update the next time i go back.
|
|
Re: Fishing Reeds
[Re: vicstric]
#11752079
07/31/16 11:56 PM
|
Joined: May 2014
Posts: 352
SK1
Angler
|
Angler
Joined: May 2014
Posts: 352 |
I 2nd the sweet beaver or creature bait with a 1/2 to 1oz barrel weight which for me comes through reeds better than the bullet weights. Also don't be afraid to pitch it as deep as possible into the reeds. It's usually an aggressive bite and some will hang you up/ break you off.If there's current or deep water nearby concentrate on those areas. Hope this info helps. Tightlines
|
|
Re: Fishing Reeds
[Re: vicstric]
#11752327
08/01/16 02:17 AM
|
Joined: Dec 2015
Posts: 731
toofy
Pro Angler
|
Pro Angler
Joined: Dec 2015
Posts: 731 |
I'm glad to find this thread because I was just about to post the same question today. I went to the reeds around the island on Eagle Mountain this morning and got skunked. Started at sunrise at 6:30 and spent about 2 hours there. Trolled completely around the island. I saw fish jumping at the surface so I used topwater most of the time (popper and buzzbait). Never got a bite. I found an area on the north side of the island where I could navigate deep inside the reeds to where the trees are. I thought this would be a less pressured area but no bites. The wind was blowing from the south and it was pretty choppy, but when I got to the north side it was very calm. Sounds like I should have tried a jig. I just got more serious about bass fishing about 6 months ago and read about how jigs are the greatest thing since flush toilets. Never gotten a bite on a jig. And I have gotten good at accuracy with flipping/pitching but still no luck. On an unrelated note, anybody know what that building is on the northeast corner of the island? Here are the google maps coordinates: https://www.google.com/maps/place/32%C2%B054'40.4%22N+97%C2%B029'38.8%22W/@32.91123,-97.4946455,135m/data=!3m2!1e3!4b1!4m5!3m4!1s0x0:0x0!8m2!3d32.91123!4d-97.494097 https://www.google.com/maps/place/32%C2%...23!4d-97.494097
|
|
Re: Fishing Reeds
[Re: toofy]
#11752517
08/01/16 10:42 AM
|
Joined: Jul 2007
Posts: 825
C_Fisher
Pro Angler
|
Pro Angler
Joined: Jul 2007
Posts: 825 |
I'm glad to find this thread because I was just about to post the same question today. I went to the reeds around the island on Eagle Mountain this morning and got skunked. Started at sunrise at 6:30 and spent about 2 hours there. Trolled completely around the island. I saw fish jumping at the surface so I used topwater most of the time (popper and buzzbait). Never got a bite. I found an area on the north side of the island where I could navigate deep inside the reeds to where the trees are. I thought this would be a less pressured area but no bites. The wind was blowing from the south and it was pretty choppy, but when I got to the north side it was very calm. Sounds like I should have tried a jig. I just got more serious about bass fishing about 6 months ago and read about how jigs are the greatest thing since flush toilets. Never gotten a bite on a jig. And I have gotten good at accuracy with flipping/pitching but still no luck. On an unrelated note, anybody know what that building is on the northeast corner of the island? Here are the google maps coordinates: https://www.google.com/maps/place/32%C2%B054'40.4%22N+97%C2%B029'38.8%22W/@32.91123,-97.4946455,135m/data=!3m2!1e3!4b1!4m5!3m4!1s0x0:0x0!8m2!3d32.91123!4d-97.494097 https://www.google.com/maps/place/32%C2%...23!4d-97.494097 picnic area
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|