Forums59
Topics1,037,853
Posts13,935,648
Members144,150
|
Most Online39,925 Dec 30th, 2023
|
|
johnson/evinrude mechanics
#11649625
06/06/16 01:07 PM
|
Joined: Sep 2008
Posts: 120,584
hopalong
OP
Pescador Loco
|
OP
Pescador Loco
Joined: Sep 2008
Posts: 120,584 |
need your opinion here.
96 faststrike bogging finally got to run the boat some, here are the symptoms.
starts and idles fine, will run up with the hotfoot fine in neutral.
let it warm up while I parked the truck and total it idled was about 5 mins. before I took off so the engine was warm.
got on plane fine, ran up to 5800 rpm fine and ran about 3/4 of a mile then the bogging started again, just loses power but does not die if I put it in N then it idles fine again.
let it sit and fished some, about an hr. then tried again, same result.
while idling back to the ramp (hopefully to avoid possible damage) I tried my choke, pushed the key in and the engine promptly died/flooded, started again and let idle a min or so then again pushed the key and it died, this time it took 5-6 attempts to restart but did when the cyls. cleared.
what do y'all think? I am leaning toward a power pack going out (believe the one I put in a little over a yr ago is a cdi unit). voltage shows good and the stator (oem) is pretty new so don't think that is a concern.
really don't want to toss parts at it and will take to a mech if needed but prefer to hear the diagnostic wizards on here. thanks in advance.
Last edited by hopalong; 06/06/16 01:53 PM.
" Hop, set the hook"! hopalong 99,999 TexDawg 99,999 FJB! not my president by a long shot!
lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
|
|
Re: johnson/evinrude mechanics
[Re: hopalong]
#11650641
06/06/16 09:46 PM
|
Joined: May 2003
Posts: 11,586
gary purdy
TFF Guru
|
TFF Guru
Joined: May 2003
Posts: 11,586 |
Have had a lot of problems Hop with those blankady blank plastic carbs on these motors dripping fuel in the venturi`s. They become warped. Look down the throats while running. Gas it and if bad you will see fuel come out the front of the carb. The other possibles are you are down a cylinder because of a power pack or coil. Check to make sure the timming roller hasn`t backed off of the throttle arm on top. Up here: http://www.boats.net/parts/search/BRP/EVINRUDE/1996/SE150WTPXB/THROTTLE%20LINKAGE/parts.html
The world will not be destroyed by those who do evil, but by those who watch them without doing anything. Remember what He has done and remember that He is not done yet!-- GOD IS GOOD
|
|
Re: johnson/evinrude mechanics
[Re: hopalong]
#11653279
06/08/16 01:27 AM
|
Joined: Jan 2009
Posts: 1,645
spankyttx
Extreme Angler
|
Extreme Angler
Joined: Jan 2009
Posts: 1,645 |
i've seen an elect fuel pump do that, a weak pump will run fine at idle to low but may not be able to keep up at wot, just a thought
LI-SI-WI-NWI
|
|
Re: johnson/evinrude mechanics
[Re: hopalong]
#11660139
06/11/16 03:23 AM
|
Joined: Oct 2014
Posts: 495
ctapp
Angler
|
Angler
Joined: Oct 2014
Posts: 495 |
Hop can u send me a pic of your motor with the mr gasket pump mine just went out 96 175 intruder mine did tht to had to sand down one of the bowls to seal it an replaced another thnks hop
Pro staff// Guns n Clubs GAMBLER Lures Duckett fishing
|
|
Re: johnson/evinrude mechanics
[Re: spankyttx]
#11661406
06/12/16 01:09 AM
|
Joined: Sep 2008
Posts: 120,584
hopalong
OP
Pescador Loco
|
OP
Pescador Loco
Joined: Sep 2008
Posts: 120,584 |
i've seen an elect fuel pump do that, a weak pump will run fine at idle to low but may not be able to keep up at wot, just a thought spanky wins this round, fuel filter was messed up and pump was not keeping up, all fixed now.
" Hop, set the hook"! hopalong 99,999 TexDawg 99,999 FJB! not my president by a long shot!
lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|