|
Forums59
Topics1,039,182
Posts13,960,486
Members144,192
| |
Most Online39,925
Dec 30th, 2023
|
|
 Scupper mounting a transducer question
#11396280
02/06/16 04:25 PM
|
Joined: Mar 2011
Posts: 826
justindfw
OP
Pro Angler
|
|
OP
Pro Angler
Joined: Mar 2011
Posts: 826 |
Just got a diff yak. New yak has scuffer holes none are center of the yak . I'd i make a homemade mount it might be tilted slightly because of where the transducer will sit on the bottom of the yak. Is this ok or does it have to be perfect? On my sit in I just used through hull but with the sit I got I need to figure out the best mounting
|
|
|
Re: Scupper mounting a transducer question
[Re: justindfw]
#11396347
02/06/16 05:06 PM
|
Joined: Jun 2002
Posts: 2,560
HERROUTDOORS
Extreme Angler
|
|
Extreme Angler
Joined: Jun 2002
Posts: 2,560 |
It will work fine. I have mine mounted through the scupper with no issues.
|
|
|
Re: Scupper mounting a transducer question
[Re: justindfw]
#11435272
02/24/16 11:29 AM
|
Joined: Feb 2005
Posts: 130
NjTexan
Outdoorsman
|
|
Outdoorsman
Joined: Feb 2005
Posts: 130 |
As far as I can tell it does not have to be perfect to work fine. You should try to get it as close as possible using the eyeball scale.
I've had the same FF over the same water using both the scupper mount that was off level by a good 3/8" and a track arm mount and I couldn't tell any difference in the FF display.
Last edited by NjTexan; 02/24/16 11:31 AM.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
