Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Jbrown18, Travisly4, Russline, Rev.,Dr.Thaddious, Robere
107989 Registered Users
Top Posters
TexDawg 88591
hopalong 78895
Pilothawk 76386
John175® 67548
JDavis7873® 67390
FattyMcButterpants 60868
Derek 🐝 60239
Tritonman 57988
LoneStarSon® 54394
SkeeterRonnie 53365
facebook
Forum Stats
107989 Members
60 Forums
810843 Topics
10269588 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11396280 - 02/06/16 10:25 AM Scupper mounting a transducer question
justindfw Online   content
Pro Angler

Registered: 03/18/11
Posts: 799
Loc: alvarado
Just got a diff yak. New yak has scuffer holes none are center of the yak . I'd i make a homemade mount it might be tilted slightly because of where the transducer will sit on the bottom of the yak. Is this ok or does it have to be perfect? On my sit in I just used through hull but with the sit I got I need to figure out the best mounting

Top
#11396347 - 02/06/16 11:06 AM Re: Scupper mounting a transducer question [Re: justindfw]
HERROUTDOORS Offline
Extreme Angler

Registered: 06/12/02
Posts: 2536
Loc: Richardson, Texas
It will work fine. I have mine mounted through the scupper with no issues.

Top
#11435272 - 02/24/16 05:29 AM Re: Scupper mounting a transducer question [Re: justindfw]
NjTexan Offline
Outdoorsman

Registered: 02/16/05
Posts: 130
Loc: Kyle,Texas
As far as I can tell it does not have to be perfect to work fine. You should try to get it as close as possible using the eyeball scale.

I've had the same FF over the same water using both the scupper mount that was off level by a good 3/8" and a track arm mount and I couldn't tell any difference in the FF display.


Edited by NjTexan (02/24/16 05:31 AM)

Top



© 1998-2018 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide