Business has been good and I've bought a new, larger guide boat. My former guide boat is now for sale. My last trip fished in it was 31 Dec. It is ready to fish as-is, right now.
Located on Stillhouse Hollow Reservoir near Killeen/Temple/Belton. Boat ramp is 1.5 miles away for an easy test drive when you call ahead.PROS
*Custom-made Center Console American Bay Boat rolled-edge skiff
*Made at the American Deckboat plant in Gatesville, TX, 2002
*2011 Honda 4-stroke 90 hp outboard still under warranty until Sep. 2016
*Maintenance logs kept and available
*Never in saltwater
*Length 18' 4"
*Beam 8' 0" (this is a very wide boat for its length and is very, very stable)
*Center console with tach, trim, and hour gauges
*New (2015) binnacle mount shifter
*New (2015) shift and throttle cables
*Front casting deck wide enough for 3 men with pedestal seating
*5 pedestal bases on front casting deck for 1, 2, or 3 man configuration
*Minn Kota 70 lbs thrust, 24 volt Maxxum trolling motor with foot pedal
*6 Bee-Ready rod holders, 3 on each gunwale
*2 Scotty trolling rod holders, 1 on each gunwale
*23 vertical rod holder tubes
*26 gallon fuel tank under console
*Stingray Hydrofoil Stabilizer
*Three 12 volt batteries
*On-board Guest battery charger, 6 amp, 2 bank, 3 amps per bank*Humminbird 1199SI with Side Imaging on console networked to bow unit (230 hours)
*Humminbird 1199SI with Side Imaging on bow networked to console unit (41 hours)
*Humminbird 360 Imaging device on transom, networked to 2 sonar units
*RoadMaster single axle, leaf spring, galvanized trailer with no rust
*Trailer bunk boards - new (2015)
*Full size spare tire on trailer bracket
*New LED trailer lights & reflectors (2015)
*Electronic trailer brakes with 7 pin connector and truck cab controller
*Large under-casting deck 3-compartment storage
*Large under-rear deck 2 compartment storage
*Switch panel for navigation/anchor light, bilge, aerator, and horn
*Stainless steel steering wheel with suicide knob
*Stainless steel grab rails on sides and top of console
*360 degree rubrail
*2-prong plug run to console for shad tank/accessories*Line-X brand spray-on keel guard for hull protection when beaching
*Pull ropes installed for console/bow, console/stern, and bow/stern wiring
*Original owner's manual
*Honda shop manual for outboard maintenance and repair
*Top speed 32 mphCONS
*Used as the primary vessel for my guide service for 13 years, so it has obvious wear-and-tear.
*Thru-floor hull repair performed in 2009 left minor high spots in the gelcoat on the floor behind the console and these have since worn through the gel coat. Floor also creaks a bit at the repair seam.
*Motor hours are higher than would be encountered under weekend-only usage, but motor is still under warranty. 1,870 hours.
Reduced to $10,400 on 17 March
Cash or bank-to-bank wire only. No personal checks, no cashier's checks, no PayPal.