texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
TraeMartin, Power-Pole CS, T-Rigger, JoeGoes, EcKo
119150 Registered Users
Top Posters(All Time)
hopalong 120,565
TexDawg 119,511
Bigbob_FTW 94,879
John175☮ 85,892
Pilothawk 83,259
Bob Davis 81,478
Mark Perry 72,280
Derek 🐝 68,311
JDavis7873 67,416
Forum Statistics
Forums59
Topics1,037,815
Posts13,934,987
Members144,150
Most Online39,925
Dec 30th, 2023
Print Thread
Advice needed on disconnecting oil injection #11394598 02/05/16 07:30 PM
Joined: Jul 2014
Posts: 47
Majak Offline OP
Outdoorsman
OP Offline
Outdoorsman
Joined: Jul 2014
Posts: 47
Ok guys hopefully I can get some help here. I have a 95 mariner magnum 200 efi. I've had it for a couple years now and it runs great. The oil injection is still in use at this time. Which has not posed any sort of problem but I was advised by a couple of people that that's just a blown motor waiting to happen being that the plastic gear that runs the oiler is known to fail and chances are that it would be too late. So what is the best method to disconnect it? I've seen the block off plates but I'm not wanting to get in the motor to do all of that. Should I just remove the lines and cap off in the inlets or just reroute the oiler back to the tank and let it continue to work but mix my own fuel? I'm not familiar with that system so I just didn't know if I starved the pump if that will cause that part to fail and shred. Any advice is appreciated.

Re: Advice needed on disconnecting oil injection [Re: Majak] #11394616 02/05/16 07:38 PM
Joined: Aug 2006
Posts: 7,182
steve@S2Marine Offline
TFF Celebrity
Offline
TFF Celebrity
Joined: Aug 2006
Posts: 7,182
pull the pump out and get the block off kit.
pre mix your oil and your good to go.

the block off kit has a rod that goes down and contacts the gear on the crankshaft.
no need to go into the motor.

i've done that to every 200 efi i've had when running pro stock.


www.hydrodynamics-usa.com
info@hydrodynamics-usa.com
903-763-5225
www.s2marine.com
s2marinesales@gmail.com
Blazer Boats, Gambler boats and Legend Craft Boats




Re: Advice needed on disconnecting oil injection [Re: Majak] #11394696 02/05/16 08:09 PM
Joined: Jul 2014
Posts: 47
Majak Offline OP
Outdoorsman
OP Offline
Outdoorsman
Joined: Jul 2014
Posts: 47
Thank you sir! I had gotten confused with all the forums I've read. Cut and dry works the best for me. Also I purchased a jack plate from you last year for my Champion. Worked out great. Thanks for the advice.

Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3