Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Jstdad, Lakesniper, Coach Blalock, Colt_haus, fritzcallier
104780 Registered Users
Top Posters
TexDawg 84851
hopalong 77212
Pilothawk 74577
JDavis7873® 67382
John175 ® 63062
FattyMcButterpants 60663
Derek 🐝 57534
Tritonman 57445
SkeeterRonnie 52884
LoneStarSon® 52768
facebook
Forum Stats
104780 Members
60 Forums
840793 Topics
11996663 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11314120 - 12/31/15 10:51 AM 2013 21I jackplate height
CHUNK-N-WINDING Offline
Pro Angler

Registered: 01/04/08
Posts: 700
Loc: Sulphur Springs
Hey skeeter Guys, I have a 2013 Skeeter 21I 250SHO 2 PP Blades that I have yet to see 70. I have a slidemaster manual jackplate that I have been told needs to come up at least an inch to 1 1/2. I am wondering if I can get some feedback on how many dots y'all have showing on the top of the jackplate as I am searching for a one and done setting to get the sweetspot. Thanks
_________________________



Top
#11314343 - 12/31/15 12:02 PM Re: 2013 21I jackplate height [Re: CHUNK-N-WINDING]
NoWeighers Online   content
Pro Angler

Registered: 05/09/07
Posts: 789
Loc: Zapata, TX
I have a 2012 21I and I have 4.5 dots showing.. Set top of slide right in the middle of the fifth dot..

With me, gear, and full of fuel will usually run 72-73.. 74-75 low on fuel with a little chop..

No blades or poles..
_________________________
James Bendele
Falcon Lake Tackle
"On the eighth day, Man invented the Fish Hook."

Top
#11314510 - 12/31/15 01:23 PM Re: 2013 21I jackplate height [Re: CHUNK-N-WINDING]
MATT REGAN Online   content
Angler

Registered: 10/03/07
Posts: 306
Loc: FORT WORTH
I can't be much help on jackplate setting because i have a atlas hid, plate,but i will tell you that i have 2 blades and full fuel and myself i will just see 70 when i get it trimmed just right and about 5800 to 5900 rpm,The most i ever see is 72 when lite on fuel.

Top
#11314880 - 12/31/15 04:34 PM Re: 2013 21I jackplate height [Re: CHUNK-N-WINDING]
B.Hollingshead Offline
Extreme Angler

Registered: 03/11/09
Posts: 1787
Loc: ft.worth
With your motor level and boat level your prop shaft should not be any lower then 2 1/2" below the center of your running pad. That should get you close and work up from there.
_________________________
Branden Hollingshead

30-DD's and counting

Top
#11318143 - 01/02/16 11:45 AM Re: 2013 21I jackplate height [Re: CHUNK-N-WINDING]
CHUNK-N-WINDING Offline
Pro Angler

Registered: 01/04/08
Posts: 700
Loc: Sulphur Springs
Thanks guys! Gives me some ideas.
_________________________



Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide