The bilge pumps have wiring harness connectors (typically gray) in the rigging compartment, usually immediately behind the livewell. After doing a panel reset, try to run each pump indivually to see what triggers the error blink. The auto pump has a 3 wire connector; the manual pump has a 2 wire connector.
If you can't get the reset to clear the blink with billge pumps connected, unplug both pumps then try reset again. This will indicate whether the bilge pumps are causing the issue.
The same procedure can help with livewell pumps as well.
Edited by Flippin-Out (12/21/15 08:36 AM)