Forums59
Topics1,038,879
Posts13,954,696
Members144,181
|
Most Online39,925 Dec 30th, 2023
|
|
Lowrance HDS9T possible interference???
#11140074
10/01/15 11:40 PM
|
Joined: Jan 2015
Posts: 119
jbaker33
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Jan 2015
Posts: 119 |
So about 4 months ago I purchased a brand new Skeeter ZX250. Love the boat love everything EXCEPT the Lowrance HDS9T. I have had many people who are experienced with electronics look at it and say puzzled, "Man, I don't know what the heck is up with this" So my question for those that have experienced something like this is could it be interference causing the graph to look like there is crud all over the place? Yes the software/firmware has been updated, Have the LSS2 transducer installed when the boat was purchased, and the front unit is hooked up to the transducer built into the MinnKota. The installation tab on the unit is set correctly and the last bit of info that i think could be causing it is the interference from some other piece of electronics. How can this be corrected?
|
|
Re: Lowrance HDS9T possible interference???
[Re: jbaker33]
#11140084
10/01/15 11:45 PM
|
Joined: Dec 2008
Posts: 16,147
grout-scout
TFF Guru
|
TFF Guru
Joined: Dec 2008
Posts: 16,147 |
Have you done a hard reset or restore defaults to it? Save any wypts first to a sd card. Many times there will be a glitch and the hard reset or default will clear it up.
Also, are you running both graphs when this happens? Could be the crosstalk between the ducers if they are on the same freq.
Last edited by grout-scout; 10/01/15 11:47 PM.
|
|
Re: Lowrance HDS9T possible interference???
[Re: jbaker33]
#11145941
10/05/15 04:03 AM
|
Joined: Jan 2015
Posts: 119
jbaker33
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Jan 2015
Posts: 119 |
Yes done a hard reset as well as only running one transducer at a time. Is there a way to identify or eliminate interference through wiring
|
|
Re: Lowrance HDS9T possible interference???
[Re: jbaker33]
#11146203
10/05/15 01:17 PM
|
Joined: Dec 2008
Posts: 16,147
grout-scout
TFF Guru
|
TFF Guru
Joined: Dec 2008
Posts: 16,147 |
Are they wired to the cranking battery? Are you wired directly to the battery or through an accessory panel? Helps to go straight to the battery. If you have it installed that way then you might have a graph or transducer issue.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|