Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
jwhit88, Fisherman954, Mud Liger, Joe111, EL Mike
102702 Registered Users
Top Posters
TexDawg 82848
hopalong 74363
Pilothawk 73411
JDavis7873® 67377
FattyMcButterpants 60518
John175 ® 59859
Tritonman 56816
Derek 56400
SkeeterRonnie 52450
LoneStarSon® 52210
facebook
Forum Stats
102702 Members
61 Forums
858747 Topics
11265232 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11102658 - 09/14/15 09:45 AM Wiring Harness on Evinrude....
Dave F Offline
Green Horn

Registered: 08/28/15
Posts: 8
Loc: Fort Worth, TX
I just replaced my wiring harness, stator, rectifier/regulator and power pack on my 1986 Evinrude V4 140 HP outboard. The regulator overheated causing damage to all these parts and that is why I had to replace them. I have the wiring diagram but am having some issues understanding or deciphering it.

At the end of the harness there are 2 wires that are brownish in color and have pin connectors on them. I am trying to figure out where they go. does anyone have any idea what they are for? I don't see any obvious place to connect them....
Do you know a good mechanic that is good with electrical/ignition issues that I can contact?

THANKS!


Edited by Dave F (09/14/15 02:00 PM)

Top
#11103709 - 09/14/15 06:49 PM Re: Wiring Harness on Evinrude.... [Re: Dave F]
whybass Online   content
Outdoorsman

Registered: 06/20/12
Posts: 121
Loc: beaumont,Tx
if the wires have a yellow tracer on them they are probably for the kill switch although most are black with yellow tracer.

Top
#11104406 - 09/15/15 06:28 AM Re: Wiring Harness on Evinrude.... [Re: Dave F]
Dave F Offline
Green Horn

Registered: 08/28/15
Posts: 8
Loc: Fort Worth, TX
Just discovered that they are for the sensors that are on each side of the engine. All good! Now I hope it starts after I get everything hooked up. Thanks guys!

Top



© 1998-2016 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide