Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
BetterFisherThanMatt, YakinGundy, maxrob, masonjar, FayetteCountyFish
103544 Registered Users
Top Posters
TexDawg 84014
hopalong 75490
Pilothawk 74023
JDavis7873® 67380
John175 ® 61820
FattyMcButterpants 60638
Tritonman 57281
Derek 57020
SkeeterRonnie 52608
LoneStarSon® 52537
facebook
Forum Stats
103544 Members
61 Forums
869130 Topics
11404566 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11027291 - 08/07/15 01:56 PM Fuel Hose Question
tdavis184 Offline
Outdoorsman

Registered: 09/12/06
Posts: 128
Loc: Longview, Tx
1995 Mercury 200hp EFI Xri. I have replaced the fuel hoses from tanks to engine with new approved hose. Now the question...Are the molded hoses on the engine (the ones under the cowling)..are they just as susceptible to ethanol breakdown as the tank hoses? Regardless would I be money ahead to replace due to age (20 years old) if so, are the molded hoses a Mercury item or can they be replaced using bulk hose that is cut to length? My concern in using bulk hose is hose pinching (kinking) in the elbows. Your thoughts ????

Top
#11027704 - 08/07/15 04:30 PM Re: Fuel Hose Question [Re: tdavis184]
gary purdy Online   content
TFF Guru

Registered: 05/24/03
Posts: 10770
Loc: Littlefield Tx & Lake A. H. US...
I only use the heavy re-enforced wall marine hose. Where the hose come out of the fuel pump and goes to the fuel filter and where the hose comes from the filter back to the VST will kink and close off if you use thin wall automotive hose. That is not molded hoses on the fuel lines their. The molded ones are at the bottom of the electric fuel pump and at the top of the VST for the fuel filter and fuel regulator. Do not over look the filter inside of the bottom hose on the electric fuel pump.
_________________________
“The world will not be destroyed by those who do evil, but by those who watch them without doing anything” GOD IS GOOD

Top



© 1998-2016 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide