Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
MJS34, BigBen_TX, Tom_Doe, VnJ, Tony Funes
106386 Registered Users
Top Posters
TexDawg 86951
hopalong 78792
Pilothawk 75584
JDavis7873® 67385
John175 ® 65743
FattyMcButterpants 60793
Derek 🐝 58896
Tritonman 57724
LoneStarSon® 53720
SkeeterRonnie 53105
facebook
Forum Stats
106386 Members
61 Forums
812200 Topics
10254386 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#11011166 - 07/30/15 10:48 PM Pump setups for lake drawing
Nissen2000 Offline
Outdoorsman

Registered: 05/21/08
Posts: 42
Loc: Fort Worth
Does anyone have any recommendations on what equipment you're using to draw lake water for landscape watering? I've seen a few things available but wondered what would be a good low maintenance system.
Thanks!


Edited by Nissen2000 (07/30/15 10:49 PM)

Top
#11011763 - 07/31/15 10:56 AM Re: Pump setups for lake drawing [Re: Nissen2000]
Bob Landry Offline
Extreme Angler

Registered: 08/10/11
Posts: 2662
Loc: Austin, Tx
A good start would be to check with the governing authority for the lake and see what the requirements are and what permits, if any, are needed. LCRA has been cracking down on waterfront landowners around here for pumping water from Lake Travis. Evidently, the right amount of money has to be put in the right pocket.
_________________________
2015 Seaark 1872 MV CC Etec-90
Two Helix 12 CHIRP SI's, , MinnKota Riptide ST80/i-pilot Link, Bob's Hydraulic
2018 Robalo R180 CC, Yamaha 115

Bitter Gun Owner
Bitter Clinger
Armed Infidel

Top
#11014438 - 08/01/15 10:01 PM Re: Pump setups for lake drawing [Re: Nissen2000]
machinist Offline
Extreme Angler

Registered: 08/22/06
Posts: 1757
Loc: Lake Graham, Lot 30
This is what I use http://www.powerequipmentdirect.com/Red-Lion-RL22G10-3W2V-Water-Pump/p7510.html
When our lake was down it was 200 feet from the pump to the well house. From there it is another 250
feet to the front of my lot. I have a faucet about every 50 feet and I was able to run 6 sprinklers
at a time. The pump has 1 1/4 inch discharge and it needs to be run to a tee so you can put a pressure
switch to protect the pump in case of low suction/flow. Then I have 1 inch main line with 3/4 inch
off for each faucet.

Johnny
_________________________
I fish on the edge and stay out of the middle

99 BassCat Jag w/225 Merc Optimax

Top
#11014880 - 08/02/15 09:50 AM Re: Pump setups for lake drawing [Re: Nissen2000]
Nissen2000 Offline
Outdoorsman

Registered: 05/21/08
Posts: 42
Loc: Fort Worth
Thanks! Will check them out.

Top



© 1998-2017 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide