Forums59
Topics1,038,956
Posts13,956,396
Members144,184
|
Most Online39,925 Dec 30th, 2023
|
|
Motor question
#10944596
06/28/15 01:22 PM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
Have power to motor, turn the key and the gauges all light up and sound off but it won't even try to turn over, new cranking battery Friday night and all batteries show good charge. Any advise or knowledge would be helpful. It's an evinrude etec
|
|
Re: Motor question
[Re: Santonio Banderas]
#10944607
06/28/15 01:33 PM
|
Joined: Jan 2008
Posts: 19,792
Donald Harper
TFF Guru
|
TFF Guru
Joined: Jan 2008
Posts: 19,792 |
Check kill switch first. Not only the hookup but the relay on the motor. A tech. can tell you which wire to remove to see if it will fire up. Then move to the shift lever sensor.
I have had batteries test OK. Then change it out to find there wasn't enough cranking amps..
Each person you work with holds some promise to your future success. Websiite Sponsors: www.eletewater.com - Staying Hydrated www.lakeoviachic.com - Booking Mexico Trips 20 Hot Spot Mapping - GPS Contour Chips - Custom Spinner Baits - Jigs -Spooks Pure Extracts - Minnow-Night Crawler-Crayfish-Craylic
|
|
Re: Motor question
[Re: Donald Harper]
#10944615
06/28/15 01:36 PM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
Just checked kill switch, it's in place and all wires behind it are in place, was on lake last night and rain to the ramp grabbed the trailer, got back on the boat and it wouldn't start, had just started fine 15 minutes earlier to make that run to the ramp.
|
|
Re: Motor question
[Re: Santonio Banderas]
#10944628
06/28/15 01:42 PM
|
Joined: Oct 2011
Posts: 2,758
C Worthy
Extreme Angler
|
Extreme Angler
Joined: Oct 2011
Posts: 2,758 |
Could actually be the starter solenoid.
Life is one big playground. Be sure to ride all the rides before it closes.
|
|
Re: Motor question
[Re: C Worthy]
#10944640
06/28/15 01:45 PM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
That's what I was wondering, I'm not a boat mechanic so this next one may sound off...... Will the starter cause it to not even try to turn over?
|
|
Re: Motor question
[Re: RodBreaker CWill]
#10944680
06/28/15 02:13 PM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
[quote=RodBreaker]did you have it in neutral? [/quot
Yes sir
|
|
Re: Motor question
[Re: Santonio Banderas]
#10945126
06/28/15 08:01 PM
|
Joined: Oct 2012
Posts: 548
SIR-FISH-LOT
Pro Angler
|
Pro Angler
Joined: Oct 2012
Posts: 548 |
Check the fuse to the motor. some motors has fuse inside the cowl.
Jig fisherman
|
|
Re: Motor question
[Re: Santonio Banderas]
#10945161
06/28/15 08:26 PM
|
Joined: Feb 2008
Posts: 2,100
epicoutdoors
Extreme Angler
|
Extreme Angler
Joined: Feb 2008
Posts: 2,100 |
Do you have a breaker on the Pos battery connection cable? It's usually separate from the accessory/dash wires. Sounds like water got into the ignition circuit somewhere from the rain, the vibration while running to the ramp may have helped it to work it's way in somewhere.
|
|
Re: Motor question
[Re: Santonio Banderas]
#10945731
06/29/15 02:20 AM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
Thanks to all who replied, I traced the problem back to under neath the console, the ignition connection had come a little loose...... Ran her this evening no problems!!!
|
|
Re: Motor question
[Re: Santonio Banderas]
#10945759
06/29/15 02:36 AM
|
Joined: Jun 2012
Posts: 20,704
Douglas J
TFF Guru
|
TFF Guru
Joined: Jun 2012
Posts: 20,704 |
Thanks to all who replied, I traced the problem back to under neath the console, the ignition connection had come a little loose...... Ran her this evening no problems!!! Good deal, most of the time it's something simple like that and you just have to track it down...
#MFGA
|
|
Re: Motor question
[Re: Douglas J]
#10945793
06/29/15 03:03 AM
|
Joined: Jun 2015
Posts: 656
Santonio Banderas
OP
Pro Angler
|
OP
Pro Angler
Joined: Jun 2015
Posts: 656 |
Thanks to all who replied, I traced the problem back to under neath the console, the ignition connection had come a little loose...... Ran her this evening no problems!!! Good deal, most of the time it's something simple like that and you just have to track it down... I just have to step back and calm down......
|
|
Re: Motor question
[Re: Santonio Banderas]
#10946789
06/29/15 05:37 PM
|
Joined: Jan 2012
Posts: 970
harvey walker
Pro Angler
|
Pro Angler
Joined: Jan 2012
Posts: 970 |
THANK'S for posting what the problem was, a lot of the time we never find out what happen we someone ask for help.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|