Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Possum67, wormwiggler20, rdbalcom, lanie, Bass Strike Tackle
107730 Registered Users
Top Posters
TexDawg 88362
Pilothawk 76320
JDavis7873® 67390
John175® 67188
FattyMcButterpants 60846
Derek 🐝 60031
Tritonman 57950
LoneStarSon® 54314
SkeeterRonnie 53336
Mark Perry 52109
facebook
Forum Stats
107730 Members
60 Forums
807673 Topics
10230219 Posts

Max Online: 36273 @ 01/23/13 02:34 PM
Topic Options
#10942435 - 06/26/15 04:56 PM Throttle/Hotfoot bind at WOT
cantcatch5 Offline
Extreme Angler

Registered: 06/15/06
Posts: 1706
Loc: Tyler, "Tx

My throttle sticks pretty hard at WOT and I have to pull the hotfoot back to idle with my foot. I disconnected the throttle cable so I could figure out if it was the HotFoot or cable and both work freely when disconnected. I THINK that as the Hotfoot goes down in an arc motion it is torquing the end of the throttle cable making the metal throttle cable connector piece bind on the brass throttle cable piece end. I do not see a way to adjust this to prevent it from happening. The hot foot has been on the boat since I bought it in 2005 and it seems to me that the problem is getting worse.

Has anyone else run into this problem? And if so how do you resolve it?

Any help would be greatly appreciated.
Jason

Top
#10943200 - 06/27/15 08:18 AM Re: Throttle/Hotfoot bind at WOT [Re: cantcatch5]
gary purdy Online   content
TFF Guru

Registered: 05/24/03
Posts: 11402
Loc: Littlefield Tx & Lake A. H. US...
I would suspect too much travel causing the binding. Cable is stretching or you can adjust the cable shortening in at the motor and resetting the full throttle stop.
_________________________
The world will not be destroyed by those who do evil, but by those who watch them without doing anything. Remember what He has done and remember that He is not done yet!-- GOD IS GOOD

Top
#10944838 - 06/28/15 11:14 AM Re: Throttle/Hotfoot bind at WOT [Re: cantcatch5]
whybass Offline
Outdoorsman

Registered: 06/20/12
Posts: 148
Loc: beaumont,Tx
had same problem with my hot foot and after removing it found it had some corrosion. disassembled it then lubed and reassembled and just like new. hope this helps.

Top



© 1998-2018 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide